Tumblelog by Soup.io
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.

May 26 2011

1318 b4bf 500
Ultimaker Extruder
Reposted frombernhardkubicek bernhardkubicek
1796 47e5 500
nearly everything assembled
Reposted frombernhardkubicek bernhardkubicek
6709 b6de 500
My first sucessfull Ultimaker print. Testbody 20x20mm, PLA.M3 nut.
Reposted frombernhardkubicek bernhardkubicek
7094 462f 500
Second Ultimaker print, double speed than the cube, now 80mm/sec. Build quality is not very good, imho, but, I have zero knowledge of the settings, so probably there will be big improvements soon.
Also the round outer shape is approximated by short lines, although as far as I read Repraps support arc commands. Sounds like a nice thing for Grecode, to take skeinforge output and replace approximated arcs by real arcs.
Reposted frombernhardkubicek bernhardkubicek
7477 da18 500
The roof of my second Ultimaker print is quite, well, non-air tight. I expect this to improve if I have some usefull print settings.
Reposted frombernhardkubicek bernhardkubicek
Play fullscreen
My first Ultimaker test print
Reposted frombernhardkubicek bernhardkubicek
Play fullscreen
End of the first print with my Ultimaker
Reposted frombernhardkubicek bernhardkubicek
Older posts are this way If this message doesn't go away, click anywhere on the page to continue loading posts.
Could not load more posts
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Just a second, loading more posts...
You've reached the end.

Don't be the product, buy the product!

Schweinderl